Jump to content
Ultimaker Community of 3D Printing Experts

Replacement washer in the olsson block?


Fodskammel
 Share

Recommended Posts

Posted · Replacement washer in the olsson block?

Hi there.

 

I need to replace a broken washer that keeps the temperature sensor and heater cartridge in place. (The one on the screw that goes into the olsson block)

 

Does anyone have a part name/number so I can find a replacement?

 

Thank you.

20200923_120927.jpg

  • Link to post
    Share on other sites

    Posted · Replacement washer in the olsson block?

    I think it is easier to use a washer in that size from your local hardware store. I don't think it is a special part, just a washer to prevent that the screw comes out itself. 

  • Link to post
    Share on other sites

    Posted · Replacement washer in the olsson block?
    On 9/23/2020 at 5:29 PM, Smithy said:

    I think it is easier to use a washer in that size from your local hardware store. I don't think it is a special part, just a washer to prevent that the screw comes out itself. 

     

    Common hardware stores in Denmark are unfortunately not all that well stocked. Unless it's stuff used to do home improvements, we need to order it online.

     

    And the washer is needed to keep the temperature sensor and heater cartridge in place. Without it, they are not kept in place and surface contact is not ensured.

     

  • Link to post
    Share on other sites

    Posted · Replacement washer in the olsson block?

    First measure the screw diameter.  Measure the diameter of the screw including the threads.  I think it's 3mm?

     

    Then you want a "3mm lock washer"

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...