Cura profile for Makergear M3-ID

[n2d7 0]

I am looking to use Cura with Makergear M3-ID dual extruder 3D printer. I am currently using Simplify3D (makergear provides printer profile for simplify3d) which works well. But I would like to try out the different infill patterns that are available on Cura. Has anyone developed a Cura printer profile for M3-ID?
Otherwise, how would I start to write my own printer profile for Cura

Edited October 1, 2020 by n2d7
Additions

[hdlbq 0]

Hi,

I have the same problem.

Moreover, I think that Cura is far better than Simplify3D