Need driver for Ultimaker 2

[me0815 0]

Hello,

 

i just fixed a problem i had with my Ultimaker 2 and now, when I wanted to update the FW it always shows something like: "device not migrated" so I found out that it has something to do with the drivers and so I searched for drivers to download- but found nothing.

So I wanted to ask you if someone knows where I can get the rivers from:)

 

Best regards,

 

Simon

 

(I know that coura should automatically install the drivers, but hat doesnt work somehow. also tried it with some later versions of cura)

[nallath 1,118]

What is showing that warning? Your operating system?

Also note that the FW of the UM2 hasn't been updated in quite some time now. So updating might not even be needed at all.

Edited October 20, 2020 by nallath

[me0815 0]

I had to do a reset, so I need to load the FW now. Yes, my operating System shows it.

[nallath 1,118]

You just need to install the arduino drivers. Those should do the trick.

[me0815 0]

 

well, so far so good. It works now, thanks a lot.

Right now it doesnt connect to cura and when I want so connect it to pronterface it connects but always shows "invalid baudrate" (I already tried with difrent ones).

Do you have any suggestions?

Edited October 22, 2020 by me0815