Jump to content
Ultimaker Community of 3D Printing Experts

Strati di supporto


Michele1982
 Share

Recommended Posts

Posted · Strati di supporto

Ciao, per una prova che devo effettuare,

devo riempire un supporto utilizzando il riempimento al 100%

ma che sia sempre estruso dalla stessa direzione

e no che ogni volta si mette parallelo al riempimento precedente.

Come posso fare?

  • Link to post
    Share on other sites

    Posted · Strati di supporto

    That is an interesting project.  I'm not sure how good the translation to English works.

    I tested with a 25x25x25 cube.  I can get close but Cura wants to make the trip as short as it can.  That means extrude a line up, move over, extrude down, move over, extrude a line up, etc..

    Every layer looks just like this.  No walls, no floor, no top, just infill

    Untitled.thumb.png.b384d43ec29ee5bf083139fa704d4ced.png

     

    If the project needs to:

    Extrude a line up, move over, come back, extrude a line up, move over, come back, extrude a line up, etc you will have to fool any slicer into doing that.  It is totally inefficient and goes against the programmers intent.  I am not saying it can't be done, but it may require some programming skills.

     

    I won't do the test for you, but playing with the settings in a slicer you should get to the photo above.  Here is the big clue    [ ]

     

    Good Luck!

    Greg (from Orvieto) Valiant

     

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...