UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Cura is not sending marketplace materials to my S3
Posted
· Cura is not sending marketplace materials to my S3
That's a metal filled filament. I'm not sure but is it possible that can only be printed with a CC 0.6 core? Probably not just the CC 0.6 but... if so then that would explain it?
Also you don't absolutely have to get the filament onto the printer software to load it and use the filament. Just tell the S3 you are loading ABS (to get the right approximate temperature) and then when you go to print it, the printer will complain it's the wrong material and just tell the printer to ignore that. It should print with the cura settings and ignore the fact that you told it you have ABS.
I agree however that it's nice to get the printer to know the material.
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
Recommended Posts
gr5 2,067
That's a metal filled filament. I'm not sure but is it possible that can only be printed with a CC 0.6 core? Probably not just the CC 0.6 but... if so then that would explain it?
Also you don't absolutely have to get the filament onto the printer software to load it and use the filament. Just tell the S3 you are loading ABS (to get the right approximate temperature) and then when you go to print it, the printer will complain it's the wrong material and just tell the printer to ignore that. It should print with the cura settings and ignore the fact that you told it you have ABS.
I agree however that it's nice to get the printer to know the material.
Link to post
Share on other sites