Jump to content
Ultimaker Community of 3D Printing Experts

PLA Help


classified
 Share

Recommended Posts

Posted (edited) · PLA Help

Hello,

 

I recently bought about 10kg of 1.75mm pla from 3D printing Canada. The problem is that it has inconsistent filament diameter.  I measured the PLA with my caliper and got readings as high as 1.80mm. This is a problem because I have a 2 Bowden tube printers and one direct drive printer. The Pla works fine on the direct drive printer because there's no tube for the pla to get stuck in, but on the Bowden tube printers, there's a lot of friction and it prevents proper extrusion. Is there a way to fix this, so I can get proper extrusion on the Bowden printers? Would putting in 2.85mm for the filament size in cura help or is there something else I can do to achieve proper extrusion? 

 

Thanks in advance.

 

P.S:

I know it's the filament causing this because I disassembled and reassembled the whole hotend (and there were no clogs), I replace the Bowden tube, nozzle and thermistor, I updated the firmware, and I even formatted the Sd card. I found a roll of strong hero PLA which I used before and had no issues with, and I printed with that and it extrudes without problems. 

As I said before I have 10 rolls of the filament that is giving me problems on my Bowden tube printers and I would like to use it on my Bowden tube printers, not just the direct drive one. Is there a way to to this? Also, I just checked my printer, and it stopped extruding mid print (This is with the strong hero PLA). How do I fix this and why does this happen?   

Edited by classified
  • Link to post
    Share on other sites

    Changing 1.75 to 2.85 in Cura while still using 1.75 filament is a stupid idea! One thing for sure, prints will fail, and you have a chance of damaging your printer

     

    What brand of bowdentube are you using, I know Capricorn has 1.90 and 2.00mm inner diameter bowdentube, in both cases 1.8mm should be no problem...

    • Like 1
    Link to post
    Share on other sites

    Has Mari said, I suggest you replace the tubes and instead of chaging the filament diameter in cura you can adjust the flow percentage instead; this will give you more control and a more accurate print.

    • Like 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • The Ultimaker Showcase — October 14. What's new?
        Your dear friends at Ultimaker have some exciting news and insights for you!
         
        • 0 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...