Jump to content

Setting to Reduce Travel?

pksteffen

By pksteffen
in UltiMaker Cura

 Share

Recommended Posts

pksteffen

pksteffen 0

Posted
Posted · Setting to Reduce Travel?

Listening to my Sovol SV01, I can hear that the only continuous line laid down is on the outside wall.  This is backed up by looking at the Gcode viewer see below.  The printer jumps to the end to do the two end rectangles and then comes back to do the middle rectangles which are compartments in this battery organizer. 

 

Is there a setting to optimize travel?  I'm using the generic PLA stetting in Cura. Thanks!

 

83734733_ScreenShot2021-01-03at9_13_20AM.thumb.png.2aed9507ce7d99d72bab8a72b47af826.png

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...