Jump to content
Ultimaker Community of 3D Printing Experts

Print looks melted on half of the perimeters and only for a few high layers


Recommended Posts

Posted · Print looks melted on half of the perimeters and only for a few high layers
Have you ever seen something like this? I have this chess bishop which prints fine up to a certain height. Then, on the next layers, for ~12mm, only half of the perimeters print OK, but the other half it's quite bad (see picture). Then it prints again OK up to the top. I've printed with Cura 4.8. The problem is located always on the half of the perimeter where the seam is created. I have a few ideas:
1. Something is incorrectly set in Cura settings
2. There's smth wrong with the printer when it reaches that height, with the cooling maybe. Fan is 100% though
Any advise would be highly appreciated. I'm stuck at this point.

bishop bad.jpg

  • Link to post
    Share on other sites
    Posted · Print looks melted on half of the perimeters and only for a few high layers

    It is a cooling issue, so maybe your printer cannot cool such small parts properly or the part is too small in any way.

     

    try to print more than one part in the same job, it helps often to increase the layer time.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker Transformation Summit

        On April 20 - April 23 we will host the Ultimaker Transformation Summit. Come talk to us via Live chat and get inspired by any of our relevant presentations!
        • 5 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 0 replies
    ×
    ×
    • Create New...