Jump to content

Deceleration based on geometry?


Recommended Posts

Posted · Deceleration based on geometry?


Is there a way to set acceleration parameters in a more dynamic way so that edges leading to sharp corners get much anticipated/adapted deceleration? I bet that would greatly reduce ringing with no cost for parts that do not suffer from it.


Thanks for any hint., best.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
        • 58 replies
    • Create New...