Wrong Scale on Z axis after firmware update

[matthiash 0]

Hello,

I updated the Firmware on my ultimaker and now the scale on the z axis is always wrong.

A part which is 36 mm in z direction in cura, is only 22 mm high after printing.

Any ideas what the problem is?

Cheers,

Matthias

 

[Dim3nsioneer 558]

Sounds as if the number of steps per mm is wrong in the firmware. I guess, you compiled your own version of Marlin or built it at marlinbuilder.robotfuzz.com? If it's the second, check the number there; it should be 8/3*200=533.33333 (as long as you use the standard z thread and motor). If you have an Ulticontroller, you can check there.

EDIT: You can also use the M92 code in your start.gcode (UM1, correct?)

 

[matthiash 0]

Found the problem the z axis stepper did not work probably, tightened the screws and it s working again.