Jump to content
Ultimaker Community of 3D Printing Experts

Tree Support and Support Density


Recommended Posts

Posted (edited) · Tree Support and Support Density

I noticed that, when Tree support is used, the setting Support Density is still availabe with the calculated value of 0.

 

What does Support Density mean for Tree support? The density of the branches?

 

Thank you for some clues!

Edited by curasurf
  • Link to post
    Share on other sites
    • 1 month later...
    Posted · Tree Support and Support Density

    Like on normal support it controls the amount of support infill inside the trunk or branches.  At "0%" you get the outer wall only.  At 50% you will see a lot of lines inside the trunk and branches.  Below is the definition from the "Cura Settings Explained" webpage.  You can also locate it because it is in the sticky "Cura Settings Explained" that is always the first posted thread when you visit the forum.  That may have been why there were no responses to this thread.

     

    When you go to the page there are example models with different Support Density.

     

    Support density

    This defines the density of support structures. A higher value will lead to stronger support, but these will be more difficult to remove and take more time to print.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker Transformation Summit

        On April 20 - April 23 we will host the Ultimaker Transformation Summit. Come talk to us via Live chat and get inspired by any of our relevant presentations!
        • 5 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 0 replies
    ×
    ×
    • Create New...