Jump to content

Infill lines overlap if "Connect Lines" and "Gradual Infill Steps" are ON together

Dmitrijs

By Dmitrijs
in UltiMaker Cura

 Share

Recommended Posts

Dmitrijs

Dmitrijs 0

Posted
Posted · Infill lines overlap if "Connect Lines" and "Gradual Infill Steps" are ON together

Had this since older versions and still remains in 4.8 and Arachne.

 

Infill lines overlap if "Connect Lines" and "Gradual Infill Steps" are ON together

 

These connection lines are printed right over each other and other infill lines (like Extra Infill Lines) causing huge blobs of excessive material. The number of those overlaps seem to be related to the number of gradual steps too. It looks like Cura does not apply offstep for each new line and prints it at exactly same place, where another one was already printed.

 

I have tried many different versions already. Can someone try to replicate and confirm this behaviour?

 

 

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...