Jump to content
Ultimaker Community of 3D Printing Experts

Recommended Posts

Posted · Parts knocked over

All my parts that I print on my Ultimaker S5 are being knock over. I tried different material and both print heads. At the same time the print nozzle's spit out small pieces of material onto the plate. This started about a month ago. Possibly after I installed Ulitmaker 6.1.1.    Any suggestions?   Thank you,  Klaus

  • Link to post
    Share on other sites
    Posted · Parts knocked over

    sometimes the nozzle can hit the part pretty hard when you have overhangs but your part should stick very very well such that it doesn't get knocked off.

     

    What material are you printing?  PLA?

     

  • Link to post
    Share on other sites
    Posted · Parts knocked over

    Are you using any kind of glue or spray on your glass bed?

     

    Clean the bed very well.  Probably best to remove it from the printer, clean it with scrubbing brush or spatula and hot soapy water.  Then clean it again with glass cleaner to remove any extra oils and soap.  Then put it back on the printer without getting your finger prints on the glass.

     

    Next there are so many options.  Magigoo?  hairspray?  glue stick with water?  But my favorite is elmers wood glue mixed in a jar with 10 to 20 parts water with 1 part glue.  Regular elmers glue should work well if you don't have the wood glue.  Put the lid on the jar and shake it up well then open and apply a thin layer onto the glass bed.  I use an old crappy paint brush and rinse the brush for a few seconds after each time.  Heat the bed to 60C or hotter until it dries completely.  You should be left with a very very thin layer that is almost invisible.

     

    Now print on that.  Your parts will stick really well.

     

    Also if you have parts that are more than 50% as long as the bed then consider adding brim (versus skirt).  Brim helps hold down corners - particularly square corners of parts.  Brim is under "build plate adhesion type".

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker Transformation Summit

        On April 20 - April 23 we will host the Ultimaker Transformation Summit. Come talk to us via Live chat and get inspired by any of our relevant presentations!
        • 6 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
        • 0 replies
    ×
    ×
    • Create New...