Jump to content

Need Help. Poor ABS 3D Print Quality After Core Change


Recommended Posts

Posted · Need Help. Poor ABS 3D Print Quality After Core Change

Need help on what settings do I need to change to make this print with crisp edges again.  I had to replace the print core due to the brass heads being worn out and before the replace heads I had no problems printing this design.  All sides had clean edges before but now the bottom edge is very rough and this is the same profile that I was using before.  Here is my set up: 

 

Ultimaker S5

Matterhacker ABS Black (I have tried several different brand new rolls)

Printing Profile: Engineering-Normal 0.15mm

Printing Temperature 235 (Used a temp tower to determine best temp)

Infill Density is 20%

Building Plate is 95C

Print Speed is 30mm/s

Everything else is the stock settings.

 

 

 

 

Print 3.jpg

Print 1.jpg

Print 2.jpg

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...