Jump to content
Ultimaker Community of 3D Printing Experts

Recommended Posts

Posted · General Decrease in Quality

Over the past couple months print quality on our two S5's has been decreasing. We've had this issue for the past couple prints now where the layers are offset and aren't clean. I've gone over both of them and removed any play on the axles, and the profile we are using is the same one we've been using for over a year. I'm working part-time as a lab tech and am a full-time student, so unfortunately I don't have the time or resources to do a bunch of test prints. I would greatly appreciate if someone would take a look at our print profile and give suggestions.

Core 1: eSun PLA+

Core 2: eSun PVA natural

 

Back.jpg

Side.jpg

PLAprofile.curaprofile

  • Link to post
    Share on other sites
    Posted · General Decrease in Quality

    Clean the print cores (hot and/or cold pulls), if time is more valuable than money, try replacing them with fresh ones.

     

    Open up the feeders and clean off the wheel that drives the filament.

     

    Clean off the z-screw and re-lubricate with fresh grease.

     

    Might want to consider replacing the bowden tubes as well if you have printed with them for a long time. But the first three is what I suggest starting with.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker turns 10: A look back
        Ultimaker is turning 10 years old and that means it is story telling time! We'll explore 2010-2014, traveling through the evolution of the business from the Protobox and Ultimaker Original, to the major leaps forward with the Ultimaker 2 and Ultimaker 3.
          • Like
        • 0 replies
      • Ultimaker Transformation Summit
        Visit our virtual showroom and learn more about the Ultimaker ecosystem!
        • 14 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 0 replies
    ×
    ×
    • Create New...