UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
HELPUltimaker 3 - Druckprobleme - Nachfolgedruck geht nicht
Posted
· Ultimaker 3 - Druckprobleme - Nachfolgedruck geht nicht
1 hour ago, zerspaner_gerd said:
Naja, ich hatte oben genau nach diesem Lüfter nachgefragt und auch geschrieben, ob er jedes Mal anläuft, und um "jedes Mal" zu prüfen muss man halt mal über einer längeren Zeit beobachten und nicht nur einmal hinschauen und fertig.
Wir können halt nur Hinweise geben und das Überprüfen liegt an dir, und wir müssen uns drauf verlassen das dies ordentlich geprüft wurde
Mea Culpa 😔 - Zerspaner_Gerd!!
Ich hätte ihn echt beobachten sollen - aber wie auch immer; ich bin froh, dass ich nun weiß, was es ist....
Dieses blöde Ding ist anscheinend mal gelaufen und dann wieder nicht - und wenn ich dann dabei war, ist er gelaufen. Und ja, leider (oder Gott sei Dank) muss ich meine Zeit nicht sitzend vorm 3D Drucker verbringen 😁
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
Recommended Posts
sebther2 2
Mea Culpa 😔 - Zerspaner_Gerd!!
Ich hätte ihn echt beobachten sollen - aber wie auch immer; ich bin froh, dass ich nun weiß, was es ist....
Dieses blöde Ding ist anscheinend mal gelaufen und dann wieder nicht - und wenn ich dann dabei war, ist er gelaufen. Und ja, leider (oder Gott sei Dank) muss ich meine Zeit nicht sitzend vorm 3D Drucker verbringen 😁
Aber nochmals vielen Dank für deine Hilfe!!!!
LG Helmut
Link to post
Share on other sites