Starting reprint Ultimaker S3

[Bastelfieber 0]

Hello,

 

I am missing the following features:

1. Ultimaker S3 offers a reprint, if the print fails. But if the print is OK, this is not offered. It would be very convenient, if this would be possible

2. If the material is not the right one, in Cura or the Digital factory a confirmation is needed, the same request, it would be very nice, if this could be confirmed direct at the printer. 

 

Are these functions not available or do I just not find them?

 

Best regards

 

Axel

[Smithy 1,141]

31 minutes ago, Bastelfieber said:

1. Ultimaker S3 offers a reprint, if the print fails. But if the print is OK, this is not offered. It would be very convenient, if this would be possible

It is not possible from the printer itself, but via the printers web interface you can reprint the previous jobs with just a click on a button.

 

32 minutes ago, Bastelfieber said:

2. If the material is not the right one, in Cura or the Digital factory a confirmation is needed, the same request, it would be very nice, if this could be confirmed direct at the printer. 

Hmm, as far as I know there is a notification on the printer itself to confirm it. But maybe that has changed with a newer firmware because some users complaint that they want to confirm not on the printer. But not sure.