Jump to content
Ultimaker Community of 3D Printing Experts

Unloading process doesn't work


Recommended Posts

Posted · Unloading process doesn't work

Hi everyone,

I am trying to load and unload the filament. When I press unload, the gear didn't retract out all the filament. This happened to me last time and I had to do a hot/cold pulling cleaning procedure. There was some clog. I don't think it should be a problem this time, because I just did it. 

I don't know, but could this cause the nozzle to not be printing too much? The loading process extrudes out some, but when I print, it prints out little dots.

 

I also noticed that when I was able to unload it, there were some bumps at the end where the gear and the filament may touch at.

209240207_970485597052456_7902982843947298244_n.jpg

208848900_357194759088892_7881170936531924576_n (1).jpg

207750977_544143180294952_4513369515210301768_n (1).jpg

209741210_1025721077964608_6576808755259562790_n.jpg

209397724_197859355578295_7848616083004888598_n.jpg

209605468_4200105333381944_6424050765736637684_n.jpg

  • Link to post
    Share on other sites

    Posted · Unloading process doesn't work

    As already answered in your other post, your feeder tension is not correct. Bring it to the middle position and try it again.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • The Ultimaker Showcase — October 14. What's new?
        Your dear friends at Ultimaker have some exciting news and insights for you!
         
        • 0 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...