Jump to content
Ultimaker Community of 3D Printing Experts

Printing third party materials using S5


Recommended Posts

Posted · Printing third party materials using S5

I have purchased a spool of the BASF Ultrafuse 316L and was able to add the material on Cura 3D along with the recommended print settings. However, the printer (Ultimaker S5) was unable to detect the material upon loading. I tried adjusting all the settings using Cura to overlook that and still attempt a successful print; however, the print always ends up extremely distorted from the original design. How can I let the printer detect the material so it could automatically set the optimum settings. Also, if that may not be the issue, what recommendations would you suggest when printing using this material. (BASF Ultrafuse 316L)

 

Thanks.

  • Link to post
    Share on other sites

    Posted · Printing third party materials using S5

    The printer will not auto detect the material, only UM spools are NFC enabled, but after you have installed the material profile in Cura, as mentioned above, restart Cura and during the startup Cura should send/sync the material profile to the printer. Then you can choose the material from the list during the load process.

     

    But don't expect too much from the profile on the printer, the profile and its settings are only used during the load/unload process. Everything else which is related to the print itself comes from the Cura settings. So when you are not happy with your print result, you have to tune the Cura settings, but the synced profile on the printer will not help.

     

    Unfortunately I haven't printed yet with Ultrafuse 316L, so I cannot help with settings.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...