Jump to content
Ultimaker Community of 3D Printing Experts

Differing layer heights for infill and walls


Juusoz
 Share

Recommended Posts

Posted · Differing layer heights for infill and walls

I have a suggestion that could effectively cut the print time in half for some high-detail prints.

 

Just print the outer walls with a different layer height from the rest. It would allow the print quality to look like it was printed at 0.1mm layer height, but with the print time being close to a 0.2mm layer height.

 

The supports can also be printed at a multiple of the layer height (which it already is, Support Infill Layer Thickness), but the support roof could be printed at the same layer height as the outer walls.

 

The inner walls are a bit tricky. On one hand, you could totally print it at a multiple of the outer wall height, but that could result in imperfections on the outer wall. And on the other hand, if you print it at the same layer height as the walls, it adds to the print time.

My suggestion would be to print the first inner wall at the same layer height as the outer wall with all subsequent walls with a multiple of the outer wall height. You could, of course, make this user controlled.

 

cura layer heights.jpg

  • Link to post
    Share on other sites

    Posted · Differing layer heights for infill and walls

    You could write it up over at the GitHub site.  That would insure somebody takes a look.  Not all the contributors hang around here.  Besides reporting bugs it's the place to put New Feature requests.

    • Thanks 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...