Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Is there a way to make brim on a certain part of the print?
Posted
· Is there a way to make brim on a certain part of the print?
I don't believe so. You can use an mouse ear instead of a brim though. There is a plugin in the Marketplace called "TabAntiWarping" or you can use a support blocker configured to print "As Part". Slide it under the knife point and make it "Layer Height" thick and as wide and long as you need it.
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
GregValiant 793
I don't believe so. You can use an mouse ear instead of a brim though. There is a plugin in the Marketplace called "TabAntiWarping" or you can use a support blocker configured to print "As Part". Slide it under the knife point and make it "Layer Height" thick and as wide and long as you need it.
Link to post
Share on other sites
Nexxol 0
Thank you for telling me about this TabAntiWarping plugin, i printed the blade again and it came out perfectly!
Link to post
Share on other sites