UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Printer says file is from an earlier version of Cura while using 4.10
Posted
· Printer says file is from an earlier version of Cura while using 4.10
Update your firmware. We made a mistake with older firmware versions. They would only check for the first digit of the minor version number (so it thinks that something sliced by Cura 4.10 is sliced by Cura 4.1)
Ignoring this message is also possible (but i can imagine it's a bit annoying) if you don't want to upgrade.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
Recommended Posts
nallath 1,117
Update your firmware. We made a mistake with older firmware versions. They would only check for the first digit of the minor version number (so it thinks that something sliced by Cura 4.10 is sliced by Cura 4.1)
Ignoring this message is also possible (but i can imagine it's a bit annoying) if you don't want to upgrade.
Link to post
Share on other sites