Jump to content

Cura 4.11 not responding


jbenfield

Recommended Posts

Posted · Cura 4.11 not responding

I just upgraded to 4.11 and now when I go to print, it literally hangs up for 10+ minutes with "Not responding" and maxes out one CPU. This isn't at slicing. Slicing is complete and I can even preview without a stall. But if I click "print to USB" it just spins for minutes before coming back. 

 

No other USB devices or drives are connected. Just the printer itself. 

 

4.10 was working perfectly, but even if I go back, it's now locking up as well. Some shared DLL or driver has been replaced as part of the 4.11 install and it's not playing nicely. 

 

Any ideas?

 

 

  • Link to post
    Share on other sites

    Posted · Cura 4.11 not responding

    So…another problem. Since the upgrade, there’s a fraction of a second pause between each command that it sends to the printer. It’s not hurting print quality, but it literally added 16 hours to a 9 hour estimated print.

     

    Everything is still working fine with Simplify3d on the same machine, so it’s not hardware. 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...