Jump to content

Under extrusion on supports or some kind of issue. issue


knownchild

Recommended Posts

Posted (edited) · Under extrusion on supports or some kind of issue. issue

I have edited my supports profile so that it's perfect and falls off perfect but when I switched to carbon fiber polycarbonate everything else prints fine but my supports are all messed up like they're under extruding. Does anybody have any suggestions on my supports?

IMG_20211029_160334.jpg

IMG_20211029_160029.jpg

Edited by knownchild
Picture
  • Link to post
    Share on other sites

    Posted · Under extrusion on supports or some kind of issue. issue

    You can try kicking up the "support flow" in the Material section.  I find that because the support goes down first on a layer that a long combing move or a lot of retractions in the infill can cause under-extrusion at the start of the support structure.  Under-extrusion all through the support may mean you have under-extrusion in the part as well.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...