Infill Line Multiplier Setting VANISHED

[Mlogue9 3]

Hello Evildoers and others...

 

As my printer squeaking it's way through ...

 

A few days ago I doubled up my infill line multiplier to 2, by these steps, clicking the sliding faders icon under Infill to bring up settings viz for infill, checking box next to "Infill Line Multiplier", clicking "Ok". Then I clicked into the box next to Infill Line Multiplier, hit backspace to remove the "1", typed "2" from my keypad. I do not recall if I re-hid it. I started a print that failed so bad I bought another stepper for my E. I open up cura and don't notice but it's still doubling lines, however no matter what I do, I can not access that setting. So HOW can I change it back to 1?!

 

Luckily, the print series I'm working on requires 100% infill, so I'm safe for a few hours....just use 50% but I don't like double infill unless I'm going to put BBs or something in it so it rattles.

 

This is cura 4.11, standard build for windows, under win10. I don't use 4.12 because it refuses to load past splash screen.

 

I looked for it with eyeball and search feature, no result past "Infill Line ". I chose each viz set, including "All". Stopped and restarted Cura.

 

Tired,

Matt

[nallath 1,117]

Infill line multiplier can be disabled in a few cases:

infill_sparse_density > 0 and infill_pattern != 'zigzag' and (gradual_infill_steps == 0 or not zig_zaggify_infill)

So the infill percentage must be non zero, the pattern must not be zigzag and you must either not use gradual infill steps or not connect the infill lines

[Mlogue9 3]

OH MY GOD. ZigZag f;491ing hides it. Thanks man, your reponse was a bit cryptic but thanks a lot!!!