Hi,
on first glance .mf3 aka project in cura seems to be a possibility to “can” a printjob. This does not work.
If you load a .mf3 aka project cura gives you two possibilities.
ⓐ import models. This only loads the models not the settings. So this is not a canned printjob.
ⓑ open as project. This will, on default-settings, permanently overwrite your machine settings (p.e. gcode, etc) and the material definition. So this is not a canned print-job either. I
Hi,
on first glance .mf3 aka project in cura seems to be a possibility to “can” a printjob. This does not work.
If you load a .mf3 aka project cura gives you two possibilities.
ⓐ import models. This only loads the models not the settings. So this is not a canned printjob.
ⓑ open as project. This will, on default-settings, permanently overwrite your machine settings (p.e. gcode, etc) and the material definition. So this is not a canned print-job either. I