Jump to content

Problème mécanique d'entrainement Filament

3d-impress

By 3d-impress
in Français

 Share

Recommended Posts

3d-impress

3d-impress 1

Posted
Posted · Problème mécanique d'entrainement Filament

Hello à tous!

Je voulais juste pour vous prévenir d'un petit problème qui est survenu sur mon UM2 après 3 jours d'impression et qui doit être répandu vu la conception du système...

En plein milieu de l'impression, le fil ne sortait plus, j'augmente la T° puis la vitesse de sortie du filament, mais rien y fait...

Après une minute de réflexion c'était vite vu :

en fait la roue crantée entrainant le filament derrière la machine n'était plus fixée sur son axe, la vis de maintient complètement dévissée!

bien qu'elle soit visible, impossible de la revisser, obligé de tout démonter, et c'est pas facile...

Donc si vous avez un problème similaire, ne cherchez pas et faites bien attention en démontant le système.

Enlevez le filament d'abords et ensuite démontez doucement le chmilblik, en retenant bien la position de chaque truc, ça prends du temps au remontage!

En espérant que ça puisse aider certains makers !

 

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...