Jump to content
Ultimaker Community of 3D Printing Experts

Need fast help please!


qwarks

Recommended Posts

Posted · Need fast help please!

I've just finished assembeling my ultimaker today! Weeee! I ran two prints with RepG and the firmware it came with - needless to say, there are room for improvement.

So i downloaded the newest Skeinforge Pypy (win32-SkeinPyPy-NewUI-Beta4) and ran the wizard. When it asked me if i wanted to uograde the firmware to Marlin i did so and thats when the probelms began.

I can no longer connect to the printer COM port, not from Skeinforge or from RepG.

What am i missing?

My computer runs Vista 64 bit.

Any help is appreciated.

Ultimaker_Original_User_Manual.pdf

  • Link to post
    Share on other sites
    Posted · Need fast help please!

    Set your com speed to 250000 in printerface, and it should connect without problems (assuming the right port is selected).

    the marlin firmware sets the speed automatically to 250000, and repg sometimes/mostly can't connect at that speed.

  • Link to post
    Share on other sites
    Posted · Need fast help please!
    Set your com speed to 250000 in printerface, and it should connect without problems (assuming the right port is selected).

    the marlin firmware sets the speed automatically to 250000, and repg sometimes/mostly can't connect at that speed.

    Its fixed in replicatorG, but you need the development version in order to make it work.

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...