Jump to content
Ultimaker Community of 3D Printing Experts

Why my ultimaker 2 sounds like it is having a hiccup?

Recommended Posts

Posted (edited) · Why my ultimaker 2 sounds like it is having a hiccup?

Hi attached is the video of me trying to do flow rate calibration and seems like the hot end move like it has a hiccup for a moment. What could be the cause of the problem? 


Layer Height .3mm

Initial layer height .8mm

Line width .8mm

Wall thickness 0

Wall line count 1

Top and bottom thickness 0.0 mm

infill 0%

Material flow 100%

Print speed 30mm/s

No retraction enabled 


Attached is the zip file of the video i took . The problem is at around 3s and last second.

Thank you for your advices.



Edited by mnidannydang
video at wrong place
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • Ultimaker showcase | April 2022 | 4pm CEST | 10am EDT
        I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot! 
          • Thanks
          • Like
        • 4 replies
      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    • Create New...