Jump to content

Prusa MK3 Nozzle Drag / Z-Lift?

djbetterly

By djbetterly
in UltiMaker Cura

 Share

Recommended Posts

djbetterly

djbetterly 0

Posted
Posted · Prusa MK3 Nozzle Drag / Z-Lift?

I’ve been using Cura for a while with my Prusa, I love it!  However, since v5 has come out, I’m suddenly getting nozzle drag marks on my prints.  The prints look great except for those darn drag marks.  Any guidance on this?

 

things I’ve done..

-Proper calculation of extrusion multiplier

-calibrated z-offset

-adjusted z-lift but have yet to see any improvement. 
 

any other suggestions?

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...