Jump to content

S3 Leveling Sensor Issues


sb66

Recommended Posts

Posted (edited) · S3 Leveling Sensor Issues

I have a relatively new S3 with an erratic levelling sensor.

 

Firmware 7.0.3 is installed which now has a "Leveling sensor test" in the diagnostics menu.

On completion of the test the screen displays a "Noise" reading does anyone know what is a good noise reading and what is a bad noise reading. Mine randomly varies between 4.9 and 23.8 !

 

Saving log files to USB reveals  a ????_sensor_reset.log !

Is there an  explanation for the data in this log ?

What is a good/bad Capacitive_baseline ?

 

 

Thanks in advance for any help.

 

 

 

Edited by sb66
  • Link to post
    Share on other sites

    • 3 weeks later...
    Posted · S3 Leveling Sensor Issues

    Found this support article. 

     

    https://support.ultimaker.com/hc/en-us/articles/360011576000-ER45-Capacitive-sensor-low-performance-or-interference-detected

     

    If the printer reports "interference on the signal" consistently and you encounter frequent issues with active leveling, please contact support.

    If you require further support, please contact us by submitting a ticket.

    Please ensure to include the error number (ERXX) and your printer's log files.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...