Cura 5 vs. Cura 4.13.1 print quality

[SkullCandy 0]

Hi everyone.

 

I did a lot of tweaking and tuning to figure out why my prints are bad near the seam line. It looks like under extruding just prior to the Z seam.

I do not use coasting.

 

After several attempts, I went back to cura 4.13.1 and the problem is solved.

 

See the attached pic.

 

the clean print is from Cura 4.13.1

[stejan 1]

Im also having problems with 5, mainly unnecessary travel moves and weird start points. I have also gone back to 4.13.1 for the time being.

[JTMD 19]

Me three.  I cant see anything that 5 is supposed to do that I need, and when I tried it, it caused more effort than it was worth.

[nallath 1,117]

Are you perhaps printing multiple objects at the same time? The default order of the walls were changed. So if you're printing multiple objects, that might have a noticeable effect.