Jump to content
Ultimaker Community of 3D Printing Experts

A quick Question about retraction settings


Johnmgg
 Share

Recommended Posts

Posted · A quick Question about retraction settings

Hi All, 

Just a Quick question. So, there are two settings in CURA 5.0.Retraction Speed and Retract Retraction Speed. What is the difference? Right now I am just going to set both at 45mm/s.

  • Link to post
    Share on other sites

    Posted · A quick Question about retraction settings

    The "Retraction Speed" setting is Momma and "Retraction Retract Speed" and "Retraction Prime Speed" are the daughters.  When linked - the Retraction Speed will apply to both retract and prime.  You can have different speeds for retract and prime as well.

    If there is an "fx" next to the "...Retract Speed" or the "...Prime Speed" you can click on the "fx" to re-link it to the main "Retraction Speed" setting.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 13 replies
    ×
    ×
    • Create New...