Jump to content
Ultimaker Community of 3D Printing Experts

problem with Brim/skirt


Recommended Posts

Posted · problem with Brim/skirt

Until today everything in cura was fine, then all of a sudden it started printing Brims and skirts on one side of the print, causing issues with printing. The print now overlaps the Brim/skirt. I have not tried a raft but I am sure the same thing would happen. Any ideas this is Cura 5.0. I have 3 printers, same thing will happen on each. Anycube Vyper, Ender 5, ender 3. I've tried unchecking brim on outside, same  thing will happen

cura.thumb.png.5433e7dc5137a1049f37f927d0c80127.png

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
        • 13 replies
    ×
    ×
    • Create New...