Jump to content

Stringing in middle of part


Lez0

Recommended Posts

Posted · Stringing in middle of part

Hi all

I'm using Cura 4:11.0 and I need to stop the nozzle from moving in the middle of this part as I'm getting stringing.

Material is TPU so very stingy.

I have tried a small test piece, see attached.

How do I stop the nozzle from travelling in the middle of this part. It's a long tube that fits over something so any stringing inside will be impossible to remove.

As you can see it has 4 slots that seem to be causing the problem, I don't mind stringing in the slots.

Can anybody point me in the right direction as I have tried all sorts of settings but can't seem to get the right one.

Thanks in advance.

Lez

3D-Print.png

Photo 19-08-2022, 12 03 00.jpg

Sleeve-R2-test.stl

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...