Jump to content

Bridge Coasting Bug? Cura don't coast before bridge line


Recommended Posts

Posted (edited) · Bridge Coasting Bug? Cura don't coast before bridge line



As shown below, clearly the outer wall path is a bridge print. and Cura see this bridge as it changes flow for the straight bridging section, however it chose not to coast just for the outer wall, this is physically caused sagging bridge issue on my print.

Note** on the contrary, the inner wall bridge path coasts. I've had a lot of bridge and sagging issues with this particular print due to the numerous bridge features. But I was able to resolve most of the issues by tweeking the bridge parameter, but this is a particular feature where the software doesn't coast for me and the issue persist.



Edited by leedav11
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    • Create New...