Jump to content

Infill travel optimization not available in Cura 5?

corwin_x

By corwin_x
in UltiMaker Cura

 Share
Go to solution Solved by Cuq,

Recommended Posts

corwin_x

corwin_x 0

Posted
Posted · Infill travel optimization not available in Cura 5?

Hi,

 

after upgrading to cura 5.0.0 (and 5.1.0 now) I noticed that the infill travel optimization has dissapeared from experimental settings. It can be enabled in the Visibility menu but does not show up anyways in the settings. Does it happen for anyone else? Or are there some dependencies? I have not seen any listed in the toolpit for the settings though...

    • Link to post
    Share on other sites
    • 1 month later...

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Followers 2
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...