Cura Seams to Be Shrinking Model After Slicing

[artisticmusician 1]

So when I run the slicer it seems that cura is shrinking the model. The fact is I know it's shrinking the model because I printed without checking the preview and the print was very small. Is there a setting I accidentally edited that is causing this? I appreciate any help. Thanks.

Edited September 26, 2022 by artisticmusician

[ahoeben 1,986]

1 hour ago, artisticmusician said:

Is there a setting I accidentally edited that is causing this? I appreciate any help.

You would be making it much easier for people to help you if you shared a project file. Use File -> Save project..., and upload the file to something like google drive or dropbox so you can share a link to it. With that project file we get to see all your settings (in addition to the model).

Edited September 25, 2022 by ahoeben

[artisticmusician 1]

8 hours ago, ahoeben said:

You would be making it much easier for people to help you if you shared a project file. Use File -> Save project..., and upload the file to something like google drive or dropbox so you can share a link to it. With that project file we get to see all your settings (in addition to the model).

Thanks I have added the Cura file to the post.

 

CE3PRO_ElephantHead.3mf

[ahoeben 1,986]

You set the "Scaling Factor Shrinkage Compensation" to 60%. Set that back to 100%, and your issue will be fixed.

[artisticmusician 1]

Thank you. Very much!