Jump to content

Cura 5.2.1 not extruding correctly after first layer


Em0hawk

Recommended Posts

Posted · Cura 5.2.1 not extruding correctly after first layer

I was using Cura 5.1.1 without issue, updated to 5.2.1 and now after the first layer is done it seems to retract the filament too far. Then when the second layer starts I can see the extruder pushing the filament but not far enough to extrude anything.

I know this is a Cura issue because I sliced the same model in PrusaSlicer and that worked.

I put a mark on the filament after the first layer and can see that mark never enters the extruder. It just goes back and forth and never pushes through. Yet the first layer is perfect.

I have an Ender 3 pro but this shouldn't matter considering the fact I know its a slicer problem.

 

Any I clues would be welcome.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 27 replies
    ×
    ×
    • Create New...