Jump to content

Out of round prints on an Ultimaker S5

stravanator

By stravanator
in Improve your 3D prints

 Share

Recommended Posts

stravanator

stravanator 0

Posted
Posted · Out of round prints on an Ultimaker S5

I have an S5 (R1) and I just printed a bunch of 1 inch round knobs. They look good, but if you measure them, they are out of round by 0.02 inches. Shouldn't the S5 print more accurately than that?  I used Ultimaker PLA for the print and default print parameters.  I just oiled the guide rods and greased the z-axis screw.  Motor belts are tight and no side to side slop in the drive axles.  My next step will be to print some test parts to figure out if the problem is X-axis, Y-axis, or both.  Any suggestions on how to improve the accuracy of my prints?

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      • Ultimaker Cura 5.6 stable released

        Ultimaker Cura 5.6 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura now supports Method series printers!
         
        A year after the merger of Ultimaker and MakerBotQQ, we have unlocked the ability for users of our Method series printers to slice files using UltiMaker Cura. As of this release, users can find profiles for our Method and Method XL printers, as well as material profiles for ABS-R, ABS-CF, and RapidRinse. Meaning it’s now possible to use either Cura or the existing cloud-slicing software CloudPrint when printing with these printers or materials
        • 4 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...