Jump to content

How to print both surface and solid


mikedkelly
Go to solution Solved by GregValiant,

Recommended Posts

Posted · How to print both surface and solid

Are there settings in Cura to print this object? I can do it by adding enough bottom layers to print the solid, but then the large circle prints with those layers as well. I need the large circle to print as a single wall. The solid part is thin enough that it does not require infill, but either way is fine. Thanks for any suggestions.

Test Print.png

  • Link to post
    Share on other sites

    Posted · How to print both surface and solid

    In such case ( and if the design of the part is the real final design and not a sample part) I would use a Cylinder as Cutting Mesh Modifier for the bigger cylinder.

     

    image.thumb.png.c93137ac43203940fa1c83d42e2f6298.png

    • Like 3
    Link to post
    Share on other sites

    Posted · How to print both surface and solid

    Thank you both for your suggestions. This was the simplest representation of my part, but you've really opened my eyes on what is possible.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...