threshold angle seam in Arachne

[mafi 0]

In the new Arachne Version i get an seam in outerwall, it correlats with the Wall Transitioning threshold angle, would be nice to set it to 0° lowest value is 1°
Is there a way to get a clean outerwall as before arachne?
 

[MariMakes 178]

Hey @mafi,

 

There is no easy way to turn of the variable line width other than going back to Cura 4.13.
There is probably a reason why you can't set the setting to 0°.
 

There are other settings that you can use to influence this behavior.  You can read more about them here: 

https://support.ultimaker.com/hc/en-us/articles/4792077687068

In your case I think Wall transition Length, Wall Transitioning Filter Margin or Minimum Wall Width can help here.

We can help you better if you include your Project File. 

It contains the printer and settings we need for troubleshooting. 
To save a project file go to File -> Save project.