UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
Recommended Posts
SandervG 1,519
For me it was always http://www.thingiverse.com/thing:8757 one, the hollow pyramid.
(ohnoooooo he made a link to thingiverse).
I always had it sunk in the bottom a couple of mm so the bottom would not take that long.
But it gives you a damn good idea on what settings to use for your filament if you want to print with an overhang and without any stringing.
Atleast... from my experience
Link to post
Share on other sites