Once you use it you will never want to use regular pla again
Once you use it you will never want to use regular pla again
PLA+ is PLA that has been enhanced by adding modifiers during PLA synthesis.The mechanical properties (flexibility, strength, ductility, etc.) of PLA+ are superior. 3D printed models from PLA+ filament have a smoother surface and better appearance.
Edited by Garcias
Recommended Posts
Smithy 1,144
PLA+ is just a name from Sunlu, other venders call it ToughPLA or PolyMax,.....
It is much stronger/stiffer than normal PLA, not so brittle. It can be, depends on the vendor, stronger than ABS, but it still has the same low heat resistance as normal PLA.
Personally I like this kind of PLA, it strong for most cases where I don't need a higher heat resistance and it prints easy like normal PLA. Give it a try....
Link to post
Share on other sites