Cura 5.2.2 Option for First and Last Layer - Possible Feature Request?

[MichlKl 0]

Hello,

I am printing a gasket with a smooth first and last layer (smoothing). Since I use adhesive stick to improve bed adhesion, this layer becomes quite rough after several prints. Unfortunately, this uneven surface is transferred to the printed object.

1. One possible solution to improve this issue might be for the print head to initially smooth the print bed (with adhesive stick) without filament, by moving and ironing over the print area at a small distance.

2. Additionally, I need the print head to lift up and move away from the object for the last layer. If the printer passes over the print object, it unnecessarily creates a groove on the surface due to the nozzle. To minimize stringing for TPM filaments, the print settings are configured in a way that the print head only moves over printed areas. However, this is not ideal for the last layer, so separate parameters should be available for the last layer.

Looking forward to your feedback.

Edited June 18, 2023 by MichlKl