How to create gcode for only 2nd part of a model

[drobble 0]

Hi folks,

I'm wondering, is it possible in Cura v 5.2.1 to create a gcode file from a model starting at the 'n' layer of the model?

e.g. the full model has 487 layers. The print failed at the (estimated) 220th layer.

Can I slice it again but only for the remaining layers past '220'?

Or should I use a gcode splitter program or even manipulate the gcode file manually?

Any help is much appreciated.

Stationcura.3MF

[obewan 36]

Just sink the model into the bed upto the desired height and then slice the part that is above the bed.

 

[drobble 0]

5 hours ago, obewan said:

Just sink the model into the bed upto the desired height and then slice the part that is above the bed.

 

Thanks, I just found the same suggestion in the Cura online help. Just running the second part of my print (1 hour left). I hope it will turn out nicely. Thanks again.