Jump to content

Change printing order on first layer ?

Go to solution Solved by der_groddi,

Recommended Posts

Posted · Change printing order on first layer ?

Hello community,


in the attached pictures you can see the progress on my first layer for this object. The problem is that Cura wants to print the green circles first and only then fill the area with the yellow lines. Is there a way to have the infill printed first, so they act as some sort of brim for the circles?


The circles are really small and they will not stick to the bed, so my print is not successful.


Cura Version 5.3.1, attached is the project file as well.


Thanks for your adivce.



Screenshot 2023-06-21 090536.jpg

Screenshot 2023-06-21 090526.jpg


  • Link to post
    Share on other sites

    • Solution
    Posted · Change printing order on first layer ?

    I think I "solved" it.


    I reduced my printing speed for the first layer to 15mm/s and now it seems to print my circles with good adhesion.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    • Create New...