Normal Supports are not sticking

[hutch-e 0]

Like the new normal supports with no outer walls. saves material. However, am finding that they don't stick to the insides enough to remain stable on the inside of volumes to support overhangs. I have had to use duct tape to hold them in place.

[MariMakes 178]

Hey @hutch-e

 

Welcome to the UltiMaker Community 🎉
I split your issue from the Cura 5.4 discussion because we need some more information.
Because Ducktaping should not be part of your 3D printing process 🤔

 

I'll need a little bit more information from you.

Do you have a project file for us? It contains the printer and settings we need for troubleshooting. 

To save a project file go to File -> Save project.

Do you have a picture of how your printjob failed?

Thank you 🙏