Jump to content

pause at height when printing will beep, but won't actually pause


Recommended Posts

Posted · pause at height when printing will beep, but won't actually pause

I didn't like the way the firmware 'Ender3Marlin2.0.6HW4.2.7BLTouch' did it's bed leveling. it would be right on the edge of the bed. So I installed the 'Marlin2.0.1  BLtouch V1.1.2 Non-adapter board firmware TMC2225.' It levels beautifully. But when I do a pause at height, it beeps and then doesn't actually pause. It's like a race to change the filament before it starts again. I'm probably being picky and will just install the firmware that works best, but just wanted to know if this is something that sounds familiar and maybe had an easy fix.

Thanks

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...