Jump to content

PA-6-CF Engineering Intent Properties UMS5 & UMS7

ben_lockwood

By ben_lockwood
in UltiMaker Cura

 Share

Recommended Posts

ben_lockwood

ben_lockwood 1

Posted
Posted · PA-6-CF Engineering Intent Properties UMS5 & UMS7

Hi!

I am using Polymakers PA6-CF in both my UM S7 & S5. I have been having some problems with stringing but that may be due to the filament being "Wet". On the S5 I have been running the Engineering Intent Properties for this material on the S5. I just got in the S7 and went to change the property to engineering and it was not there. Is this something that is not supported for the S7 yet or am I missing something. It seems like it should be there as it is a new printer and very similar to the S5.

 

Thanks!

Ben 

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...